| A complete
range of turntable stretch film packaging machines
with conventional plate and pallet-jack versions
capable of covering the most ample operating
requirements in the various market segments. They are
characterized by their high modularity, strong
standardization of the mechanical, electric and
electronic components. |
|
|
|
|
|
|
RotoPlat Models: |
|
Jolly :
semi-automatic stretch wrapping turntable. |
|
106/FRD :
Spool carriage with mechanical brake on return roller.
Stretch film tension manually adjustable. The carriage
is fitted with a special device allowing an easy film
binding to pallet base. |
|
306/FR :
Spool carriage with electromagnetic brake on return
roller. Stretch film tension adjustable from panel
board. Brake coupling after cycle start for easy film
binding to pallet base. |
|
406/FS :
Spool carriage with roller fractioned stretch system.
Pre-stretch ratio adjustable from 0% up 200% by
electromagnetic clutch from panel board. Clutch
coupling after cycle start for easy film binding to
pallet base. |
|
506/PFS :
Spool carriage with powered fractioned stretch system.
Pre-stretch ratio adjustable from 0% up 250% by
electromagnetic clutch from panel board. Force to the
load controlled by patented electronic device. |
|
706 /
PVS :
Spool carriage with two independent motors.
The continuous and separate control of roller stretch
ratios electronically controlled from 0% to 400%. The
force to the load is controlled by a patented
electronic device. The PVS roll carriage utilized the
"QLS" system (Quick Load System) for easy and quick
film loading, is fitted with the anti-falling device
and with the safety stop at spool carriage the bottom. |
|
Technical Specifications: |
|
Rotoplat:
technology and innovation for high performance
- Rotation speed adjustable from panel board
with acceleration and deceleration controlled by
inverter
- Phase stopping point (+/- 20 mm)
- Load height sensing photocell
- Up/down spool carriage speed with 20 %
average overlapping synchronized with table
rotation speed
- Control board by microprocessor with digital
push buttons for adjustment and selection of
load wrapping parameters
|
|
|
Parameters adjustable from control panel: |
- Bottom wraps number
- Top wraps number
- Table rotation speed
- Roll carriage speed (option)
- Photocell sensing delay
- Film stretching (FR, FS, PFS)
- Cycles selectable from control panel:
• Full wrapping (up & down)
• Single cycle (only upward)
• Single cycle (only downward)
• Top sheet wrapping cycle
• Cycle with reinforcement wraps
• Top platen wrapping cycle (option)
• Memorization of 4 working cycles and
selectable from panel
• Synoptic panel for diagnosis (only for
Rotoplat 506/pfs and Rotoplat 706/pvs)
- Standard supply voltage:
400 V. 3 PH + N- 50/60 Hz
230 V. 3 PH - 50/60 Hz
230 V. 1 PH -50/60 Hz
|
|
|
Options: |
- Up/ down roll carriage speed adjustment by
frequency changer
- Plate diameter 1800 mm. for loads 1200x1200
mm.( not for trans-pallet)
- Mast for loads 2800 mm. high
- Ramp for 1650 mm. plate diameter
- Ramp for 1800 mm. plate diameter
- Pneumatic top platen (stroke 800 mm.) for
loads 2400 mm. high
- Pneumatic top-platen (stroke 800 mm.) loads
2800 mm. high.
|
|
Home
